![]() ![]() Those settings worked generally, but I began to experience trouble immediately with my Apple TV's ability to reach Netflix, which signaled a problem with the network. After several abortive calls to AT&T ConnectTech, a CT supervisor (on the phone from somewhere far afield, across the sea) struggled to walk me through me some settings for my new Airport Extreme. I recently switched to AT&T U-verse and as previously, with my DSL setup, I wanted to put my Airport Extreme in charge of internet traffic generally and wireless traffic in particular, but the AT&T Arris modem/router does not allow a true bridge mode setting. ![]() Another iMac is connected directly to the Airport router. When the wireless network is working, it supports 2 iPads, 2 iPad minis, an iMac, a MacBook and 2 iPhones. The devices show a strong signal even when they are remote and cannot connect. On the other hand, I can't explain why the wireless devices work when they are close to the Airport router. On the one hand, everything worked fine until the U-Verse equipment update yesterday. After reconnecting, they would be fine in the remote location for a while until they failed again. Interestingly, they would work when they were taken nearer the router. He wondered if there could be a static IP address for the Airport Extreme.Įverything worked well until this afternoon when the iPads used on the lower floor disconnected from the network. He was concerned that it might conflict with the Airport Extreme that also uses 192.168.1.254 and DHCP. He was concerned that AT&T's equipment had to use DHCP with 192.168.1.254 to connect the TVs. When the system came up ten minutes later, all devices were able to connect to our wireless network. The tech reset the network remotely which disconnected all the services (phone, Internet, TV). This appeared to work, but before the call was over, the network access failed again. They reset the factory settings and their equipment and changed the channel on the modem from 1 to 11. I talked with AT&T technical support today. When I checked the wi-fi settings, the iPads would show that the devices were connected, even though they could not access the Internet. The wireless drives would display the message: No network connection or Enter the network password. This was resolved by disconnecting the the power to the Airport Extreme, waiting 5-8 minutes, and reconnecting the power. Last night we had a problem with our wireless devices (a MacBook, 4 iPads, and an iMac. Initially, it looked liked everything was working well. AT&T had to replace the network interface and modem. In 2010 we switched Internet providers to AT&T U-Verse (along with TV), but kept the Airport Extreme as the wireless router (per the recommendation of the AT&T tech). We have used an Airport Extreme for our wireless network successfully since 2008. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |